ULTRA 2 Mast

A carbon foil mast designed for precision

The mast connects your supports to the entire foil. Its rigidity influences how you feel the front wing and control its movements, especially when the forces increase or the wingspan becomes significant.

The ULTRA 2 has been developed to limit deformations in bending and twisting. It offers a precise response to changes in support and reduces the feeling of lag between the rider's action and the foil's reaction.

An ultra high modulus carbon construction

The construction of the ULTRA 2 uses ultra high modulus carbon to combine rigidity and steering precision. Its structure and geometry are designed together: the sections of the mast evolve along its height to respond to forces while maintaining a slim profile in its lower part.

This design seeks a balance between mechanical properties and hydrodynamic glide. The goal is to maintain a stable foil under load while limiting the drag of the mast in the water.

In pumpfoil: precise impulses and controlled rhythm

In dockstart and long-distance pumping, each impulse stresses the mast. With a large wingspan, its rigidity becomes essential to maintain readable supports and a controlled trajectory.

The ULTRA 2 transmits the movements of the board with precision to accompany the accelerations and variations in cadence. It allows for a better feel of the wing's behavior and to adjust its pumping throughout the run.

In wingfoil and downwind: controlling large wings

High aspect ratio wings offer glide, but also exert significant forces on the mast. The rigidity of the ULTRA 2 helps maintain precise handling during direction changes and support points.

In wingfoil, it supports accelerations, transitions, and freefly phases. In downwind, it provides solid support to engage curves, adjust trajectory, and connect the swells.

In surf foil and kitefoil: a direct response in maneuvers

In surf foil, the ULTRA 2 offers precise references during turns and support changes. Its rigidity allows for sharp control of the foil, both at the entry and exit of the turn.

In kitefoil, it is suitable for riders looking for a rigid mast for dynamic navigation and technical maneuvers. The same construction allows for varying practices while maintaining a direct feel underfoot.

Note, its rather significant chord gives it a fairly "rail" handling compared to other models like the Kronos or the Vario.

What mast length to choose?

The ULTRA 2 is offered in three lengths to adapt your foil to your practice and your body of water.

• 75 cm: to favor a shorter set and increased stiffness for equivalent construction. An interesting length for pumping on flat water or when the available depth is limited.

• 80 cm : a versatile compromise between flight height, control, and stiffness, to alternate between pumping and other disciplines.

• 85 cm : to have more margin above the water, especially in choppy conditions, swell, and in wingfoiling.

The choice also depends on your level, your front wing, and the usual sailing conditions.

If you have any doubts about your choice, our team can help you make the right one according to your profile, your desires, and your budget.

Included with the mast :

• Neoprene cover usable with foil mounted.

• Complete screw kit: 2x M6 30mm (fuselage) + 4x T-Nuts M6 with 20mm screws (board)